Portable Baptistry Cabinet with Removable Heater

Allow 8–12 weeks for delivery

This well-made portable baptistry features a fiberglass interior tub and a cabinet grade oak plywood cabinet. 

• Minister remains dry, outside baptistry
• Removable wooden steps included with baptistry (Steps will be on the right as viewed from the pews. Left entry available by special request. No extra charge.)
• Fiberglass Tub with built in seat on inside of cabinet allows candidate to be baptised from seated position.
• Included Wheel Kit includes a heavy-duty steel frame with 6 locking heavy duty casters. Wheel kit is removable and wheels swivel which makes rolling easier and distributes the weight to about 80lbs per wheel which can help protect flooring. We do not recommend rolling the unit when filled with water. When baptizing, we recommend you either remove the unit from the wheel frame and place on the ground or place wooden blocks or 2 length's of 4x4 under the cabinet to add support for the wheel frame.
• Wooden Communion top is Included.
• Removable Immersion heater with 120v cord and plug.
• Portable baptistry cabinet made of cabinet-grade OAK
• Optional Communion Panel and handrail available
• EMPTY WEIGHT about 500 lbs

This unit comes with a drain.

• We use 2 coats of Minwax Wood Finish Stain and 1 coat of sealer.

SPECIAL SALE! Portable Baptistry INCLUDES: Fiberglass tank with drain, locking caster wheels (6), and rear-access drain panel.

ALSO INCLUDES: Oak-stained cabinet, wooden top, wooden steps, cross, and “This Do” Communion panel (panel is unstained).

• Includes removable 120v immersion heater! (This is not a built-in circulation heater.)
• Cabinet dimensions: 32-3/4" wide x 38-1/4" tall
• Standard version is 6'4" long
• See diagram for overall measurements with wheels and lid
• Holds approximately 100 gallons
• 10-year warranty on tank and cabinet; 1-year warranty on heater
• Fill time: 15–20 minutes with a garden hose
• Heating time: approximately 6–9 hours depending on room temperature and starting water temperature
• Drain time: about 30–45 minutes with installed drain and garden hose
• 
  

SHIPPING INCLUDED: This model includes church shipping with inside delivery (first floor, no steps)*

• Some locations such as islands, remote areas, or dense urban zones (NYC, LA, Philadelphia, etc.) may require a shipping surcharge. We will contact you for approval before shipping if applicable.

Safety Warning: Always ensure children cannot access the unit when filled with water

The wooden 2x4 frame provides support to the fiberglass tub. Note the included drain in the bottom corner of the heel wall.

Here are the basic for operating the portable baptistry with heater

• After you unpack it we suggest doing test run outside.

• Wipe out the inside of the tub from any dust, dirt or debris.

• Fill with water to make sure the suction and return fittings are covered by at least an inch or two of water.

• Check for leaks.

• Plus the heater cord into the 120v power outlet.

• Test the GFCI button on the cord before each use

• Turn the temp knob to off

• Use the Air button on the side to turn the pump on

• Let pump run for a few minutes to ensure proper operation

• There is a thermostat on the face of the heater that can be adjusted

• Once water flow is established…Turn thermostat to mid point…light on heater should come on.

• Before draining unit be sure to unplug heater from power

• Remove any residual water from tub with a towel or sponge and wipe down interior

• Let completely dry before replacing lid to unit

• Refer to the Heater manual for warnings and more instructions, operational considerations, etc.