Baptistry Immersion Heater 120V with GFCI with Float and 16 foot cord

Baptistry Immersion Heater 120V with GFCI with Float and 16 foot cord

Manufacturer: HQ

Product ID: HQ-BIS-15-120GF-16

Weight: 1.00 lbs

$598.00
~~$747.00~~

Free Shipping

Add to wish list E-mail to a friend

Overview

120V - Baptistry Immersion Water Heater WITH GFCI and Low Water Float • Simple and safe baptistry heater -No plumbing required, just hang on side of baptistry wall • 120 volt for smaller baptistries under 150 gallons • 1500 watts, 15amps • Simply stick the bottom part of the unit in the water and turn it on • Adjustable thermostat with range from 55° to 104° F. • INCLUDES BUILT-in GFCI protection • 5ft power cord • NON-RETURNABLE • Ships in 1-2 days via Fedex ground • Made in USA • One Year MFG Warranty

Simply plug the cord into the 120V volt outlet and set the thermostat to the desired temperature.
Must be used in a minimum of 24" of water.
Water level safety switch prevents dry heating
High limit cutout at 118

Indicator light and on-off switch indicate when desired temperature is reached and breaks circuit when element is not in use.

No Cutting or modification to existing baptistry
Completely automatic and portable using the 60" power cord (included).
120v not recommended for pools over 150 gallons. It will not heat them very well at all.
Due to heat loss into the air, you should allow 24-36 hours to heat 100 gallons with the 120V heater.

Shipping Dimensions 46" x 19" x 3" Shipping weight 8.5 lbs
Cold riser extends to the top of container where control housing is located.
Stainless Steel Mounting brackets included
High limit cutout protects from overheating
Incoloy element

Warranty and Troubleshooting

One Year Manufacturer's limited warranty.
Follow troubleshooting steps in manual. If heater does not work, return it to manufacturer for inspection. Do not return it to Southeast Church Supply.