Church Baptistery Circulation Heater 240V 11KW

Church Baptistery Circulation Heater 240V 11KW

Manufacturer: HQ

Product ID: HQ-CH11

Weight: 20.00 lbs

$779.00
~~$950.00~~

Free Shipping

Add to wish list E-mail to a friend

Overview

Our same high, quality baptistry heater is stripped down without all the bells and whistles (such as a timer, control panel or autofill/drain functionality). Just solid, dependable proven performance in a manual baptistry circulation heater: This baptistry heater has the same heating capacity and heats just as fast as our more expensive models. • Heater runs on 208/240 volt • 11kw heating capacity • Includes circulating pump (120v pump) • Features system on light • For baptistries up to 1300 to 1500 gallons or smaller units for faster heating. • See our BAPTISTRY HEATING CHART for more details • Full Range Thermostat • High Limit Protection • Pressure Switch Activated • UL Listed (UL 1563) • Weight 23lbs • ALLOW 2-3 weeks for delivery • Space Required: 36" height x 16" wide x 10" deep • HEATER MUST BE INSTALLED VERTICALLY or Requires a sweep elbow for horizontal use • One year MFG warranty

HEATER MUST BE INSTALLED VERTICALLY or for Horizontal Installation requires a sweep elbow

Features a "set it and forget it" thermostat * High Limit Protection keeps water from getting too hot * pressure activated baptistry heater protection switch keeps heater from turning on unless water is present

You Get: Heater * Pump (plugs into heater for power) * Air controlled start/stop switch with 20 ft of tubing * 2 baptistry wall suction fittings * 1 baptistry wall return fitting * all necessary heater and pump fittings * instructions

You supply: GFCI protected circuit for heater * 1-1/2" PVC pipe, fittings and PVC cement * polyurethane sealant for wall fittings

The EQAS CH model pump can be used to circulate the baptistry water without the heater operating. You simply turn the thermostat down to its lowest setting and then turn the pump on. It will circulate without heating the water.

Electrical Requirement: 52 amp draw. Single Phase. 4 wire

Warranty Information

Hydroquip heaters carry a one year warranty from date of purchase. For all service or troubleshooting issues, please email us with your Order#. Model# and Serial # and a complete description of the issue.

You will be asked to perform basic troubleshooting to eliminate many of the most common reasons heaters appear to not be working properly (usually install errors or incorrect operating procedures).

If it is determined that the unit needs to be inspected by the factory, you will be responsible for packing up the heater and returning it to the manufacturer for inspection. DO NOT SHIP prior to receiving an authorization # or your heater will be refused. After factory testing, if it is determined that the issue is a defective product covered under warranty, the unit will be repaired and returned to you at no charge. If it is determined that the problem occurred due to improper use or installation, power surges or lightening strikes, overheating due to low water, etc., you will be notified of the repair cost and will have the option of proceeding with the repair or not. (return freight paid by factory on warranty claims and by customer on all other claims)