Candle Lighter 24 inch Solid Brass Holds standard

Manufacturer: Koleys

Product ID: K-231

Weight: 2.00 lbs

$180.00
~~$200.00~~

Free Shipping

Add to wish list E-mail to a friend

Overview

Candle Lighter Product Features: • 24 inch Solid Brass Lighter • Holds standard wax tapers • Slide switch to extend and extinguish taper • Walnut Handle • Brass Smoke Bell

K231 Candle Lighter Made of Brass with Brass finish

Made of the highest quality BRASS and then spun, forged or cast in to the piece you see.
Finished to perfection by expert craftsmen with years of church goods experience.
Our POLISHED FINISH (where indicated) reveals a rich, mirror like lustre and is often referred to as BRIGHT FINISH
Our SATIN FINISH (where indicated) gives the piece a more muted, brushed look and helps to hide fingerprints.
CARE INSTRUCTIONS for BRASS or BRONZE Churchware:The BRASS or BRONZE on most churchware is covered with a clear, protective lacquer. DO NOT use polishes or abrasive cleaners on LACQUERED church ware as this can damage the finish. Always remove jewelry and rings before handling to avoid scratching the surface. Wipe down with a clean, soft flannel cloth after use to remove finger oils. A soft, liquid soap may be used but make sure soap does not contain any abrasives. If the surface has dirt, dust or a heavy build up of oils, gently rinse under LUKEWARM water, then you can put a little liquid soap on your fingers and lightly run fingers under water to creates a sudsy mix and gently wash the surface. Be careful not to get water into the joints of shafts, stems, bases or other points. NEVER submerge in water or place in a dishwasher, water can get into the interior of the piece and cause corrosion from the inside. Dry with a soft, clean cloth and allow to air dry before putting in storage.This BRASS OR BRONZE item may also be cleaned use PLEDGE spray polish and a clean, soft cloth.