FREE SHIPPING!
Orders Over $150 that ship via UPS in the USA
(Excludes AK and HI)
Click Here For More Info
Orders Over $150 that ship via UPS in the USA
(Excludes AK and HI)
Click Here For More Info
ChurchProducts.comhas spent over$100,000since 2015 insupport ofthese groups:
|
Hover over image to zoom
CR6KW - Basic Baptistry Heater Package 6kw
- DISCONTINUED
- Replacement Basic Baptistry Circulation Water Heater
- Replace your existing baptistry heater with this "through the wall" style heater.
- The 6KW - 001 Package includes:
- 240v 6 KW heater
- 115v circulation pump with wall plug (230v pump available at additional cost and 4 week lead time, inquire.)
- pump installation kit and fittings
- Pump attaches directly to the side of your baptistry
- Suction at the bottom, heated water returned through the top.
- Features an adjustable thermostat (60° - 107°F).
- High limit switch set at 118°F to help prevent burn out
- For use with 240V single phase power. System can be used with 208V but heating is
reduced by 25%. With 120V, heating is reduced by 75%. - This unit will heat 90 gallons per hour for a 30° rise.
- One year manufacturers warranty.
- Total height 27". Uses 1" and 1 1/2" water connections.
- 6 KW is 26" tall, 25 amps @ 240V single phase.
- Center of water inlet to center of water outlet is 23 1/8" on the 6 KW.
- For safety, this unit MUST be installed/used on a GFCI protected circuit.
INSTALLATION INFO
Assemble and make up tightly the complete heater and parts as shown (except slip joint nuts). Locate the most accessible place around the Baptistry for installation. Drill a 2-1/8" diameter hole 4-1/2" up from the Baptistry floor. Smooth hole and install chrome faced inlet flush port, by loosening at slip joint nut. Apply clear RTV sealant under chrome flange. Remove any outside insulation so port rubber gasket fits against outside of fiberglass wall. Measure center to center distance exactly between inlet and outlet fittings. Locate and drill a 2-1/8" hole for top port using method stated above.
Assemble complete heating system onto installed ports. Important - Block under heater or pump to support weight - this prevents leakage of Baptistry wall fittings.
Heaters are shipped with special Installation Instructions regarding wiring, etc.
Add wood or other blocks under your Basic Circulation heater to help support its weight and protect baptistry wall fittings.
Assemble and make up tightly the complete heater and parts as shown (except slip joint nuts). Locate the most accessible place around the Baptistry for installation. Drill a 2-1/8" diameter hole 4-1/2" up from the Baptistry floor. Smooth hole and install chrome faced inlet flush port, by loosening at slip joint nut. Apply clear RTV sealant under chrome flange. Remove any outside insulation so port rubber gasket fits against outside of fiberglass wall. Measure center to center distance exactly between inlet and outlet fittings. Locate and drill a 2-1/8" hole for top port using method stated above.
Assemble complete heating system onto installed ports. Important - Block under heater or pump to support weight - this prevents leakage of Baptistry wall fittings.
Heaters are shipped with special Installation Instructions regarding wiring, etc.
Add wood or other blocks under your Basic Circulation heater to help support its weight and protect baptistry wall fittings.