Model SS-6-42HL 240 Volts Single Phase Especially Designed For Easy, Low Cost Installation Just plug in to a 240 V outlet and hang over the side of the baptistry. For safety, this heater must be plugged into a GFCI rated outlet.
This heater is ideal for portable baptistries, simply plug in and hang over the side of the baptistry using the included metal bracket or mount the unit to a length of 2 x4 that can be easily placed over the baptistry opening and removed before use. The 120 V model does not heat as quickly as the 240 V model but other than the plug they are identical.
Applications: The SS-6-42HL unit is ideally engineered for Fast Heat-Up in Water - Alkaline - Plating - Bath Heating
Construction Features Immersion section of unit made of Incoloy or Stainless Steel. All heat confined to the formed horizontal section for optimum heat efficiency. Cold riser extends to the top of container where control housing is located. 3-Conductor cord set with polarized plug included for easy installation and wiring at no extra charge. Adjustable vapor-proof thermostat control with temperature range off - 55°F to 115°F (± 3°). Hi-Limit cut out switch set at 125°F (±4°). Stainless steel mounting bracket also supplied for easy mounting. Pilot light and on-off switch provided, indicates desired temperature when reached and breaks circuit when element is not in use. Saves electricity - Saves money.
Notes: Completely automatic and portable - just plug in 42" Power Cord and operate. No cutting or damage to your present container. Although portable - your container may be cleaned without removing unit. Unit can be suspended in middle, end or side of container. No contractors required on standard SS-6-42HL Models The SS-6-42HL (6KW) will heat 60 GPH (40° R). A 750 to 1,000 gallon Baptistry can be heated in 13 to 17 hours, or one-half this time 20 degree rise in temperature. Heater can be operated on 120 volts, but power will be reduced to 1.5KW and will heat 15 GPH (40°R) or 30 GPH (20°R) 25 Amps 6000 Watts UL Listed under File # E76690
Do you need a receptacle ? - The 240v immersion heater will not plug into a standard 110v outlet. You will need a 240v circuit with an outlet. We also recommend the #230 Ground Fault Interuptor for safety & electrical code compliance (codes vary by location, be sure to use a licensed electricain for all electrical installations.
